Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
January 24, 2018, 02:59:05 AM
 
Pages: [1]
  Print  
Author Topic: tech  (Read 939 times)
0 Members and 1 Guest are viewing this topic.
dougking
Jr. Member
**

Karma: 1
Posts: 9


« on: October 11, 2010, 11:09:30 AM »

what are the valve clearenses on a 1991 rascal. metric or imperial.and how much can be skimmed safely off of the head.
Logged
Dell Boy
Ultimate Enthusiast
********

Karma: 17
Posts: 2344


« Reply #1 on: October 11, 2010, 06:06:12 PM »

0.13-0.18 m.m. or 0.005-0.007 thou. As regards skimming, not a lot. If you have corrosion indents weld repair first before skimming. Also check the block surface for corrosion indents.
Derek.
Logged

Dell Boy - The Rascal Specialist
dougking
Jr. Member
**

Karma: 1
Posts: 9


« Reply #2 on: October 13, 2010, 04:52:20 PM »

is that for inlet and exhaust
Logged
Dell Boy
Ultimate Enthusiast
********

Karma: 17
Posts: 2344


« Reply #3 on: October 13, 2010, 05:38:55 PM »

Yes, both are the same. Do inlets 1&2. Exhaust 1 &3 with the engine at top dead centre with no.1 cylinder on compression. Now turn the engine through 180 degrees until it is on the t.d.c. mark again & do 3 & 4 inlet & 2 & 4 exhaust. Derek.
Logged

Dell Boy - The Rascal Specialist
Pages: [1]
  Print  
 
Jump to: